6
Rev. 1.2
20/03/2020
SSDC-EC Hardware Manual
400-820-9661
2 Getting Started
The following items are needed:
• A 12-70VDC power supply, see the section below entitled “Choose a Power Supply” for
helping to choose the right one.
• A compatible SS or RS motor, please see the section below entitled “Recommended Motor”
• A small flat blade screwdriver for tightening the connectors screw
• A PC running Microsoft Windows XP/Vista/7/8(Using serial communication port. Prepare an
USB to Serial converter if the PC doesn’t have it.
• Install the Step-Servo Quick Tuner software
(download from MOONS website: www.moonsindustries.com )
• A power cable(included)
• A CAT5 cable, used to do the daisy-chain connection. It is also used to configure the drive.
• Optional extended motor cable(Sold separately)
• Optional extended encoder cable(Sold separately)
• Optional extended I/O cable(Sold separately)
To Next Page
Loading...
