4
Resetting
The System
Before using your Hot Water Dispenser for the
first time, or after it has been unplugged from
the mains. You must perform the following steps
to reset your Hot Water Dispensers’ heating
chamber.
Your Hot Water Dispenser will not function
if the system has not been reset.
3
Place an empty vessel, such as a measuring jug
or saucepan underneath the Dispense Nozzles (6).
4
Press the Dispense Button to reset the system.
Any remaining water will be dispensed from the
system into the vessel below. This takes
approximately 35 seconds. It is now ready for use.
2
The Dispense Button (5) will flash and the
‘Dispense Icon’ (13) will appear on the screen.
1
Plug your Hot Water Dispenser into the mains
outlet and switch on at the socket.
35
seconds
KT131004 MUK REV1.indd 8 18/02/2015 10:34
To Next Page
Loading...
