6
3
Place the required vessel (cup, pan, pot etc.) under
the Dispense Nozzles (6). One or two vessels can
be filled at the same time during each dispense
cycle, provided they are the same size.
4
Adjust the temperature of the water by pressing
the Temperature Button (4) to cycle through the
options (85,95 & 100
o
C). The water temperature
will be displayed on the screen (17).
1
If required, follow steps of 1-6 of ‘Resetting the
system’ (see page 4) to reset the system and then
discard the water. If the Hot Water Dispenser is in
standby mode, press any button to wake.
2
Pull out the Drip Tray (8) from the Main Unit (23)
(if needed).
Using the Hot
Water Dispenser
Before using your Hot Water Dispenser, or if
it has not been used for over a week, follow
these instructions to boil the maximum amount
of water, then discard to ensure the system is
flushed through.
The following instructions detail the steps to
follow to use your Hot Water Dispenser. For
Installation of the BRITA Filtration system see the
previous page.
Filtering water through the BRITA Maxtra
Cartridge takes around 4 minutes for 1.5L.
Ensure enough water has been filtered and is
ready for use in the water tank before heating.
KT131004 MUK REV1.indd 10 18/02/2015 10:34
To Next Page
Loading...
