Morphy Richards Redefine - Quick Start Guide

3
Place a vessel underneath the Dispense Nozzles
(6) and press the Dispense Button (5) to reset the
system. This takes approx. 35 seconds. Any water
dispensed during resetting should be discarded.
5
Press the Start/Stop Button (1), the Hot Water
Dispenser will pump 240ml of water into the
heating chamber and start to heat.
4
Using the Water Volume Dial (2), adjust the
Dispense Volume (15) to 240ml. Place a cup on the
Drip Tray (8) under the Dispense Nozzles (6).
6
When heated the water will automatically
dispense from the Dispense Nozzels (6) into your
cup.
1
Remove the Water Tank (7) from the Main Unit
(23). Remove the BRITA MAXTRA Cartridge (19) and
BRITA Hopper (21) from the Water Tank.
2
Fill the Water Tank with cold water and return to
your Hot Water Dispenser. Plug your Hot Water
Dispenser into the electrical socket.
Quick
Start
Guide
This quick start guide shows you the basic steps
for dispensing 240ml of hot water for a single
cup of tea or coffee. This quick start guide does
not detail the steps to use the BRITA Filtration
System.
For more detailed information on using your
new Hot Water Dispenser or BRITA Filtration
System, please read this instruction manual.
KT131004 MUK REV1.indd 7 18/02/2015 10:34