Morso 1010 - Installing Your Morsø Stove; Unpacking and Preparation; Installation Regulations and Chimney Sweep; Stove Placement and Clearances

20
DK ENG
1.1 Unpacking the stove
The legs are tted with the supplied bolts and lift the stove and set it carefully in place.
We recommend that two people perform the assembly and installation procedure.
Morsø 1010 weighs 70 kg.
1.2 Installing the stove
The stove and chimney installations MUST comply to all current National and Local Building Regu-
lations; your approved Morsø dealer or your local building control ocer can advise regarding this.
Ultimately, it is you and your installer who is responsible that the installation complies.
1.3 Chimney sweep
It may also be wise to consult your local chimney sweep before installing the stove. After your
stove has been installed, it is advisable to have the chimney checked and swept at least once a
year. In any case, if your chimney has not been used for some time, it should be inspected for
cracking, bird nests, etc. before it is put back into use.
1.4 Stove placement/clearance requirements
Minimum Clearance requirements apply if the stove is placed near to combustible materials.
Permitted clearances to combustible materials are also indicated on the data plate on the
rear of the stove.
1.0 Installing your Morsø stove