18
Mortonr Water Softener Installation & Operation Manual
MORTON WATER SOFTENER FEATURES AND SETTINGS, continued
RECHARGE NOW
Press and hold in the RECHARGE button until RE-
CHARGE NOW starts to flash in the time display
area. The softener begins an immediate regenera-
tion, and when over in about two hours, you will have
a new supply of soft water. Once started, you cannot
cancel this regeneration.
RECHARGE TONIGHT
Touch (do not hold) the RECHARGE button, and
RECHARGE TONIGHT flashes in the time display
area. A regeneration will occur at the next preset re-
generation start time. If you decide to cancel this re-
generation, before it has started, touch the same
button once more.
VACATIONNOTE .............................................................................
The Morton Demand water softener regenerates only while water is used and softening capacity must be re-
stored. For this reason, the softener will not regenerate when you are away from home for extended periods.
feature: PROGRAMMEMORY ..........................................................
If electrical power to the softener is interrupted, the
time displa y is blank, but the electronic control
keeps correct time for about 24 hours. When power
is restored, you have to reset the present time only
if the display is flashing. All other settings are main-
tained and never require resetting unless a change
is desired.
If the time is flashing after a long power outage, the
softener continues to work as it should to provide
you with soft water. However, regenerations may oc-
cur at the wrong time of day until you reset the e lec-
tronic control to the correct time of day, page 12.
setting: REGENERATION (STARTING) TIME, MAXIMUM DAYS BETWEEN REGENERATIONS,
EFFICIENCY MODE, HEAVY DUTY BACKWASH AND 97% FEATURE ......................
NOTE: Each of these settings has a factory set default value. The defaults are: Regeneration start time --
2:00AM; Ma ximum days between regenerations -- 0 (display shows dY --); Efficiency Mode -- OFF; 97% Fea-
ture -- OFF; Heavy duty backwash -- OFF. The defaults suit most installations. However, depending on water
supply quality, household peak water use hours, etc., adjustment is available to meet specific needs. To make
a change, read and do the following.
continued
To Next Page
Loading...
