To Next PageTo Next Page
Need help?Do you have a question about the Morton M45 and is the answer not in the manual?
General| Brand | Morton |
|---|---|
| Model | M45 |
| Category | Water Dispenser |
| Language | English |
Provides key measurements and diagrams of the water softener unit.
Explains the types of iron and their impact on water quality.
Discusses sediment as a water contaminant and its potential issues.
Guidelines for selecting an appropriate installation location for the softener.
Emphasizes adherence to national, state, and local plumbing regulations.
Details the necessity of an air gap for drain lines to prevent backflow.
Illustrates the correct sequence for installing water treatment components.
Instructions for connecting and routing the water softener drain hose.
Discusses pipe materials and bypass valve options for connections.
Procedures for safely shutting off the water supply before installation.
Instructions for preparing the softener unit for installation.
Guidance on positioning the water softener correctly.
Steps for connecting inlet and outlet piping to the softener.
Instructions for ensuring electrical ground continuity through the water pipe.
Details on connecting and securing the drain hose.
Instructions for connecting the overflow drain hose.
Procedures for testing the installed system for water leaks.
How to add water and salt to the brine tank.
Instructions for connecting the power supply to the unit.
Guides to setting up the softener's control panel.
Steps for sanitizing the unit after installation.
Instructions for restarting the water heater after softener installation.
Explains the meaning of different status light patterns on the control panel.
Guide to setting the current time on the softener's controller.
Instructions for inputting the water supply's hardness level.
How to configure the automatic regeneration start time.
Guide to selecting the type of salt (NaCl or KCI) used in the softener.
Explains manual recharge initiation like 'Recharge Now' and 'Recharge Tonight'.
Describes the salt level indicator light and how to set it.
Details the 'Salt Efficiency' setting and its impact on recharge frequency.
Explains the 'Clean Feature' for water with iron or sediment.
Saves salt/water by regenerating at 97% capacity.
Configures 12/24 hr clock and gallons/liters display.
Adjusts days between regenerations and backwash/rinse times.
Displays current water flow rate in GPM or LPM.
Shows average daily gallons or liters of soft water used.
Explains valve position and recharge time remaining indicators.
Describes the light inside the salt lid.
Guide on checking and refilling the salt storage tank.
Specifies recommended salt types and those not recommended.
Explains how to identify and fix salt bridges in the brine tank.
Instructions for cleaning the component responsible for brine suction.
Steps to drain the softener to prevent freeze damage.
Explains error codes and procedures for their removal.
Guides on entering diagnostic mode for system checks.
Details how to check turbine function and troubleshoot flow issues.
Explains the status of the position switch during operation.
How to restore the controller to its original settings.
Verifies proper operation of valve motor, brine fill, draw, and flow rates.
Outlines the warranty period and coverage for softener parts.
Details warranty exclusions, limitations, and legal disclaimers.
