Motec Systems E888 - Default Chapter; Table of Contents

Contents
Introduction........................................................................ 1
Overview............................................................................. 2
Inputs .................................................................................. 3
Input Pin Configuration (ADL) .............................................................................4
Outputs ............................................................................... 7
Output Configuration...........................................................................................7
E8xx Diagnostic Information .......................................... 11
Test Analogue Inputs ........................................................................................12
Test Auxiliary Outputs.......................................................................................12
Communications.............................................................. 14
CAN ..................................................................................................................14
Firmware Upgrades...........................................................................................14
Appendices....................................................................... 15
Appendix A: General Specifications..................................................................15
Appendix B: Input Characteristics .....................................................................16
Appendix C: Output Characteristics ..................................................................18
Appendix D: CAN Wiring – Multiple Device.......................................................19
Appendix E: E8xx to ADL Wiring.......................................................................20
Appendix F: E8xx to M800 Wiring.....................................................................21
Appendix G: E888 Pin List by Pin Number........................................................22
Appendix H: E816 Pin List by Pin Number........................................................23
Appendix I: E816 Connector .............................................................................24
© Copyright 2006 – Motec Pty Ltd
The information in this document is subject to change without notice.
While every effort is taken to ensure correctness, no responsibility will be taken for the consequences of any
inaccuracies or omissions in this manual.
13 January, 2006