MoTeC Introduction 1
Introduction
This manual describes the functions and specifications of the E888/E816
expander modules and their configuration for use with a MoTeC ADL. These
devices offer additional inputs and outputs into the ADL via a CAN connection.
ECU Manager software is currently being developed that will allow the M800
family of ECUs to read information from the E888/816.
This manual includes information on connecting a single expander unit to an
ADL or ADL2. The ADL2 along with the ADL2 Dash Manager software has
been designed to easily allow the connection of a second expander.
It is possible to connect a second expander unit to an ADL and a third or even
fourth unit to an ADL2 – please contact your MoTeC dealer for details in these
situations.
The SDL is capable of reading data from 8 thermocouples when connected to
an E888. It cannot read analog voltage inputs.
To Next Page
Loading...
