32
RsXs(?)
Serial resistance and serial reactance measurement
mode setting or querying command.
RpXp(?)
Parallel resistance and parallel reactance
measurement mode setting or querying command.
ZTD(?)
Impedance and angle (Deg) measurement mode
setting or querying command.
ZTR(?)
Impedance and angle (Rad) measurement mode
setting or querying command.
Example:
CPD (
set to Cp-D measurement mode)
CPD?
0.22724 0.12840 (
return value
)
DCR?
5.1029 (
return value
)
*IDN?
Queries and identifies the MT4080. This command is used to
identify the basic information of MT4080. The return value has
four fields separated by comma (,). The total length will not greater
than 100 characters. The four fields are:
1. Manufacturer Name
2. Model Number
3. Serial Number
4. Firmware Number
Example:
MOTECH,MT4080A,123456789,4.096
To Next Page
Loading...