2
Batteries.
The instrument has applications in electronic engineering labs,
production facilities, service shops, and schools. It can be used to
check ESR values of capacitors, sort values, select precision values,
measure unmarked and unknown inductors, capacitors or resistors,
and to measure capacitance, inductance, or resistance of cables,
switches, circuit board foils, etc.
The key features are as following:
Test condition:
1 Frequency : 100Hz / 120Hz / 1KHz / 10KHz /
100KHz (MT4080A only)
2. Level : 1Vrms / 0.25Vrms / 50mVrms /
1VDC (DCR only)
Measurement Parameters : Z, Ls, Lp, Cs, Cp,
DCR, ESR, D, Q and
θ
Basic Accuracy: 0.2%
Dual Liquid Crystal Display
Fast/Slow Measurement
Auto Range or Range Hold
Infrared Interface Communication
Open/Short Calibration
Primary Parameters Display:
Z : AC Impedance
DCR : DC Resistance
Ls : Serial Inductance
Lp : Parallel Inductance
Cs : Serial Capacitance
Cp : Parallel Capacitance
To Next Page
Loading...