What to do if Motion 4 Doors EvoDrive+ Door Opening System detects obstruction during closing?
If the Motion 4 Doors Door Opening System detects an obstruction during the closing cycle, make sure to check and remove any obstructions in the opening traveling area.
What to do if Motion 4 Doors EvoDrive+ Door Opening System detects obstruction during opening?
If the Motion 4 Doors Door Opening System detects an obstruction during the opening cycle, check and remove any obstructions in the opening traveling area.
What to do if Motion 4 Doors Door Opening System leaf does not move?
If the leaf of your Motion 4 Doors Door Opening System isn't moving, here are a few things to check: * Ensure the leaf can be moved manually and smoothly. * Verify the operator is not in open mode. * Confirm that I/O Accessories is switched ON. * Check that the sensors/accessories have been connected correctly.
Why is the Motion 4 Doors EvoDrive+ Door Opening System leaf moving too slow?
If the leaf of your Motion 4 Doors Door Opening System is moving too slowly: * Check if the operator is in Low Energy mode. * Ensure that no item is generating excessive friction. * Adjust parameters 11 and 12 of the display, decreasing their value. * Alternatively, adjust parameters 11 and 12 of the display, increasing their value.
What to do if Motion 4 Doors EvoDrive+ Door Opening System leaf hits users?
If the leaf of your Motion 4 Doors Door Opening System is hitting users, verify that all the sensors have been correctly adjusted.
Why Motion 4 Doors Door Opening System self-adjustment never ends?
If the self-adjustment of your Motion 4 Doors Door Opening System never ends, verify that the motor is fully covered with magnets in all of its length, from closing to opening.
Explains the different operational modes controllable via the remote.
Details how the door functions and can be operated when power is lost.
Provides instructions on how to safely clean the automatic door.
Outlines limitations, warnings, and safety advice for using the door.
Illustrates and defines hazardous zones within the automatic door system.
Discusses potential risks that may persist even after safety measures are applied.
General| Category | Door Opening System |
|---|---|
| Power Supply | 230 VAC, 50/60 Hz |
| Operating Temperature | -20°C to +50°C |
| Max Thrust | 150 N |
| Protection Class | IP20 |
| Noise Level | < 60 dB |
| Weight | 12 kg |
| Type | Sliding |
| Max Door Width (Single Leaf) | 3000 mm |
| Motor Type | DC Motor |
| Speed | 0.1 to 0.7 m/s |
| Max Door Weight (Single Leaf) | 200 kg |
To Next Page
