Motomaster Eliminator Product Manual

1413
OPERATION
Before you start
• Unpack the power inverter. Inspect the unit for damage. If the unit has been damaged, contact
the retailer immediately.
The carton should contain:
• Power inverter
• DC cable with cigarette lighter plug (J)
• DC cable for direct connection to 12 V battery (I)
• Owner’s manual
•
• Positioning of the power inverter:
DRY Do not expose to water, rain, moisture, snow or spray.
COOL
40 °C (32 °F and 104 °F). Keep it away from heating vents and direct
sunlight. We recommend using the inverter in environments not
exceeding 25 °C (77 °F).
WELL-VENTILATED
For proper cooling, allow at least 2" (5 cm) of clearance around the
inverter.
CLEAN
Choose a location that is free of any debris that could get into the
inverter.
SAFE
Do not install the inverter in a compartment with batteries or
OPERATION
Connecting the MotoMaster® Eliminator® Mobile Power Outlet
CAUTION!
Prior to connecting to the power source:
Make sure that the total wattage of the devices you are planning to connect to the power
inverter does not exceed the maximum load of the respective power outlet.
LOAD CONNECTED (W)
CONNECTION WITH
CIGARETTE LIGHTER PLUG
CONNECTION WITH
VEHICLE
Continuous load under 100 W Yes Yes
Continuous load between
100 and 240 W
No Yes
< 100 W
< 240 W
Connecting the connector cables to the power inverter
• M
the "0" position.
• Choose the DC cable (I / J) suitable for connecting the AC products that you want to operate.
CAUTION!
Only use the cables provided with your power inverter.
•
DC cabling terminals (B / C).
011-1870-6-Mobile-Power-Outlet_300W-EN-07.indd 13-14 12/13/12 7:22 PM

Motomaster Eliminator Specifications

General

Brand	Motomaster
Model	Eliminator
Category	Battery Charger
Language	English