Motorola solutions APX 900 - Adjusting the Volume of the Radio from Bluetooth Audio Device; Viewing and Clearing the Bluetooth Device Information

a. or to BT. Press the Menu Select button directly below BT to access the Bluetooth
feature screen.
b. or to Bluetooth spkr and press the Menu Select button directly below Off.
The display shows Off.
c. To return to the Home screen, press the Menu Select button directly below Exit.
• Turning off the Bluetooth audio using the preprogrammed button:
a. To route the audio routing from the headset to the radio, press the preprogrammed
Bluetooth Audio Reroute button.
You hear a short, medium-pitched tone. The display shows Speaker on.
6.21.7
Adjusting the Volume of the Radio from Bluetooth Audio Device
Prerequisites:Ensure that the Bluetooth audio device is connected to the radio.
When and where to use:
Your radio can only control the volume of OCW Bluetooth enabled audio device. If the radio is paired
with other Bluetooth enabled audio device, its volume is independent from the APX radio. In this case,
the volume is only adjustable on the device.
Procedure:
Adjust volume up/down on the Bluetooth audio device.
The radio display shows Volume XX, and you hear a short, medium-pitched tone.
6.21.8
Viewing and Clearing the Bluetooth Device Information
Procedure:
1
or to BT. Press the Menu Select button directly below BT to access the Bluetooth feature
screen.
2 or to Devices.
Once the display highlights the Devices, the display shows XX connected alternates with XX
paired.
3 Press the Menu Select button directly below Sel.
4 If there are devices being paired or connected,
or along the list of <Device Friendly
Name> to see the status of each device.
If there are no active Bluetooth devices being paired or connected, the display shows No
devices.
5 Perform one of the following actions:
• To clear the device from the list,
or to the required device, press the Menu Select
button directly below Clr.
• To exit from this function, press the Menu Select button directly below Back to return to the
previous screen without deleting the device name.
If Clr is selected, the display shows <Device Friendly Name> clear?.
MN003110A01-AK
Chapter 6: Advanced Features
90