If… Then…
Press and hold the preprogrammed Emergency button until
you hear the emergency exit tone.
a From the Home screen, swipe down the Status Bar.
b Tap Cancel and confirm the action by tapping Yes.
12.7
Exiting Emergency as Supervisor (Trunking Only)
Radios configured as Supervisor are able to cancel emergency mode of other radios. The dispatch
console must be preprogrammed to use this feature. Check with your dealer or system administrator
for more information on dispatch console supporting this feature.
Procedure:
1 Perform one of the following actions:
If… Then…
If the emergency mode is in-
itiated by other radios,
press and hold the 1-Dot (Side Middle) button and press
the Emergency button.
If the emergency mode is in-
itiated by the Supervisor,
Perform one of the following actions:
• Press and hold the Emergency button.
• Press and hold the 1-Dot (Side Middle) button and
press the Emergency button.
• Wait for console to clear emergency.
NOTICE: The following buttons combinations are supported:
• Radio 1-Dot (Side Middle) and Top (Orange) buttons.
• Radio 1-Dot (Side Middle) and accessory Top (Orange) buttons.
• Accessory 1-Dot Button and radio Top (Orange) button.
• Accessory 1-Dot Button and accessory Orange button.
MN005642A01-AG
Chapter 12: Emergency Operation
45
To Next Page
Loading...
Need help?
General
