If… Then…
NOTICE:
The Hot Mic applies to the first
voice transmission from your radio
during the Emergency call. For
subsequent transmissions in the
same Emergency call, you must
press the PTT button.
3 To exit Emergency Call, see Exiting Emergency Operation on page 44.
12.5
Sending Emergency Alarms with Emergency Calls
Procedure:
1 Press the preprogrammed Emergency button.
Your radio shows the following indications:
• The radio displays the confirmation message of a successful or unsuccessful
acknowledgment from the dispatcher.
• The radio exits Emergency Alarm and enters the Emergency Call state.
2 Perform one of the following actions based on the type of emergency call:
If… Then…
Emergency Call
a Press and hold the PTT button.
b Speak into the microphone.
c To end the transmission and wait for a
response from the dispatcher, release
the PTT button.
Emergency Call with Hot Mic Speak into the microphone.
NOTICE:
The Hot Mic applies to the first
voice transmission from your radio
during the Emergency call. For
subsequent transmissions in the
same Emergency call, you must
press the PTT button.
3 To exit Emergency Call, see Exiting Emergency Operation on page 44.
12.6
Exiting Emergency Operation
If an Emergency operation is triggered on your radio, the dispatch console or radios configured as
Supervisor can also exit the Emergency operation.
Procedure:
Perform one of the following actions:
MN005642A01-AG
Chapter 12: Emergency Operation
44
To Next Page
Loading...
Need help?
General
