QUICKSTART GUIDE | VB400 8
CONFIGURING YOUR VB400
Prior to using your VB400, your device must be configured and assigned to you
using VideoManager. For detailed information on how to configure your device,
please refer to the VideoManager User Guide.
Each VB400 requires a valid VideoManager License, in order for you to assign
devices and access footage. For further details, see the VideoManager User
Guide.
To ascertain whether your VB400 has been configured, please view the top LED
on your device. This LED will turn solid green once configured and assigned.
Your VB400 is charged, assigned and ready to use when the LEDs shown are
both solid green.
Configured, charged &
assigned Solid green light
PLEASE NOTE: If you try to use your VB400 before it has been assigned, the bottom LED on the front face of the camera will start to flash red and you
will hear an alarm tone. You will not be able to use your camera until it has been assigned.
To Next Page
Loading...
Need help?
General
