Motorola 700 Series - Configure and Environment Commands; Board Information Configuration

A
A-1
AConfigure and Environment
Commands
Configure Board Information Block
CNFG [;[I][M]]
This command is used to display and configure the board
information block. This block is resident within the Non-Volatile
RAM (NVRAM). Refer to the Debugging Package for Motorola 68K
CISC CPUs User's Manual for the actual location. The information
block contains various elements detailing specific operation
parameters of the hardware. The Debugging Package for Motorola 68K
CISC CPUs User's Manual describes the elements within the board
information block, and lists the size and logical offset of each
element. The
CNFG command does not describe the elements and
their use. The board information block contents are checksummed
for validation purposes. This checksum is the last element of the
block.
Although the factory fills all fields except the IndustryPack fields,
only these fields MUST contain correct information:
❏ MPU clock speed
❏ Ethernet address
❏ Local SCSI identifier
The board structure for the 700/800-series MVME162LX is as
follows:
162-Bug>cnfg
Board (PWA) Serial Number = " "
Board Identifier = " "
Artwork (PWA) Identifier = " "
MPU Clock Speed = "3200 "
Ethernet Address = 08003E200000
Local SCSI Identifier = "07 "
Parity Memory Mezzanine Artwork (PWA) Identifier = " "