Installation Instructions
2-17
2
6. On the chassis backplane, remove the INTERRUPT
ACKNOWLEDGE
(IACK) and BUS GRANT (BG) jumpers from the
header for the card slot occupied by the MVME162LX.
Note Some VME backplanes (e.g., those used in Motorola
‘‘Modular Chassis’’ systems) have an autojumpering
feature for automatic propagation of the IACK and BG
signals. Step 6 does not apply to such backplane
designs.
7. Connect the appropriate cable(s) to the MVME162LX panel
connectors for the EIA-232-D serial ports, SCSI port, and LAN
Ethernet port.
– Note that some cables are not provided with the
MVME162LX and must be made or purchased by the user.
(Motorola recommends shielded cable for all peripheral
connections to minimize radiation.)
8. Connect the peripheral(s) to the cable(s).
9. Install any other required VMEmodules in the system.
10. Replace the chassis cover.
11. Connect the power cable to the AC power source and turn the
equipment power ON.
To Next Page
Loading...
