To Next Page

To Previous Page

Introduction

1.3 Site Preparation

• Consult your site survey and network analysis to determine specific equipment placement,

power drops etc.

• Assign installation responsibility to the appropriate personnel.

• Identify and document where all installed components are located.

• Ensure adequate, dust-free ventilation to all installed equipment.

• Prepare Ethernet port connections.

• Verify cabling is within the maximum 100 meter allowable length.

1.4 Package Contents

The access point ships with the following:

• One AP-621 Series access point

• Installation Guide (This Guide)

• Rubber Wall Mount Spacers (4)

• LED light pipe and badge

• Wall mount screw and anchor kit

1.5 Features

• One RJ-45 console connector

• One RJ-45 Ethernet connector

• LED Indicators

• Safety wire tie point

• Wall mount slots

• Clips for suspended T-Bar mounting

• DC power connector

An AP-621 Series access point has one RJ-45 connector supporting an 10/100/1000 Ethernet port

connection and requires 802.3af compliant power from an external source.

The access point contains runtime firmware which enables the unit to boot after either a power up

or a watchdog reset. The runtime firmware on the access point can be updated via the Ethernet

interface.

AP621 IG.book Page 3 Tuesday, September 20, 2011 3:18 PM

Motorola AP-621 Series User Manual

Questions and Answers: