Motorola APX 2000 User Manual

• Switch the preprogrammed Transmit Inhibit
switch to Transmit Inhibit disabled position.
•
or to TxIn. Press the Menu Select button
below TxIn.
• Press the Transmit Inhibit programmable
button.
Note: If the user has disabled TX Inhibit via the
softkey and then moves the switch to the position
where TX Inhibit is enabled, the new value
overwrites the menu value.
The display shows Tx inhibit off. You hear a
sequence of short, high‐low tone (Transmit Inhibit
Off tone) to indicate transmission is back to normal
operation.
IMPRES Battery Annunciator
This feature displays the current capacity and
charges cycles of your battery when an IMPRES
™
Battery is powering your radio. This feature must be
enabled in your radio to see the information.
The information shown are:
Rated Capacity Percentage of current battery
capacity.
Remaining
Capacity
Remaining power of the battery
in mAh.
Estimated
Charges
Number of charges cycles the
battery has gone through.
Accessing the Battery Info screen
1
or to Batt.
2 Press the Menu Select button directly below
Batt.
The display shows the details of the battery.
3 To return to the Home screen, press the Menu
Select button directly below Exit.
General Radio Information
Your radio contains information on the following:
• Radio Information
• IP Display
• Control Assignments
• Soft ID (If enabled)
Note: The radio automatically exits the feature, if the
feature inactivity timer is enabled, when the radio is
Advanced Features
176
English

Motorola APX 2000 Specifications

General

IP Rating	IP67
Operating Temperature	-30°C to +60°C
GPS	Optional
Bluetooth	No
Frequency Range	700/800 MHz
Power Output	1-5 W (VHF), 1-3 W (700/800 MHz)
Channels	Up to 1, 000
Battery Life	Up to 10 hours (digital)
Digital Protocol	APCO P25
Frequency	VHF: 136-174 MHz, UHF: 380-470 MHz, 700/800 MHz: 764-870 MHz
Power	1-3W (700/800 MHz), 1-5W (VHF)