Motorola APX 3000

Preparing Your Radio for Use
English
5
Attaching the Battery‡
With your radio turned off, slide the battery into your radio’s
frame until the bottom latch clicks into place.
To remove the battery,
turn your radio off. Lift up
the latch then slide the
battery down to remove
the battery from your
radio.
Note:If your radio is
preprogrammed
with volatile-key
retention, the
encryption keys
are retained for
approximately 30
seconds after
battery removal.
Check with your
dealer or system
administrator for
more information.
You can view the status of
the IMPRES™ battery if your radio is using an IMPRES™
battery. See Checking the Battery Charge Status on page 71
for more information.
Battery Latch
is at the bottom
of the battery.
APX_3000_M1.book Page 5 Thursday, November 7, 2013 4:48 PM