Advanced Features
English
39
Deleting a Nuisance Channel†
If a channel continually generates unwanted calls or noise
(termed a “nuisance” channel), you can temporarily remove the
unwanted channel from the scan list.
This capability does not apply to priority channels or the
designated transmit channel.
Note: Deleting a “nuisance” channel is only possible through
the preprogrammed Nuisance Channel Delete
button.
Procedure:
1 Press and hold the preprogrammed Scan button to delete
the nuisance channel.
OR
When your radio is locked onto the channel to be deleted,
press the preprogrammed Nuisance Delete button.
2 Your radio continues scanning the remaining channels in the
list.
Restoring a Nuisance Channel
Procedure:
To restore the deleted nuisance channel, do one of the
following:
• Turn your radio off and then turning it on again.
OR
• Stop and restart a scan via the preprogrammed Scan button.
OR
• Mode change to another channel and back to the original
channel.
APX_3000_M1.book Page 39 Thursday, November 7, 2013 4:48 PM
To Next Page
Loading...
Need help?
General
