APX
TM
6000XE
17
Index
The accessory connector is located on the antenna side of
the radio. It is used to connect accessories to the radio.
Note: To prevent damage to the connector, shield it with
the connector cover when not in use.
Insert the hooked end of the cover into the slot above the
connector.
Press downward on the cover’s top to seat it in the slot.
Once in place, rotate the thumbscrew clockwise by hand
until tight.
To remove the accessory connector cover, rotate the
thumbscrew counterclockwise until it disengages from the
radio.
If the thumbscrew is too tight, use an Allen wrench to
loosen it first.
Rotate and lift the connector cover to disengage it from
the radio.
Preparing Your Radio for Use
Attaching/Removing the Accessory Connector Cover
Accessory
Connector
To Next Page
Loading...
