Motorola APX900 2 - Changing a Channel Parameter; Changing Password (Optional); Selecting a Channel Within a Zone

4 Press OK.
The radio displays Radio Param and Zn/Ch Param.
6.24.17.2
Changing Password (Optional)
Prerequisites: Radios from the Motorola Solutions factory are provisioned with a blank password. In
this case, press the OK softkey immediately at the Enter Old password: prompt to change the
password, to access the protected channels.
Procedure:
1 Press EDIT.
The radio displays Enter Old password.
2 Key in the old password and press OK to accept the entry.
The screen displays Enter New password.
3 Key in the new password and press OK to accept the entry.
The screen displays Re-enter New password.
4 Key in the new password again and press OK to accept the entry.
6.24.17.3
Selecting a Channel within a Zone
Procedure:
1 Press
or to FPP and press the Menu Select button directly below FPP.
The radio displays the Enter password screen
2 Enter the password and press the Menu Select button directly below Ok.
3 Press
or to select Zn/Ch.
4 Press or to select the required zone and press SEL to view the channels.
5 Press or to select the required channel and press SEL to access the channel
parameter.
The radio displays the channel parameter screen.
6 Press or to select the required channel parameter.
6.24.17.4
Changing a Channel Parameter
Procedure:
1 Press or to FPP and press the Menu Select button directly below FPP.
The radio displays the Enter password screen
2 Enter the password and press the Menu Select button directly below Ok.
3
or to scroll through the various information.
4 Press EDIT to edit the channel parameter.
MN003110A01-AJ
Chapter 6: Advanced Features
106