4 or to Delete All and press the Menu Select button directly below Sel .
The display shows Delete All saved waypnts Confirm?.
5 Press the Menu Select button directly below Yes to delete all waypoints or press the Menu
Select button directly below No to return to the Waypoints main screen.
The display shows All saved waypnts deleted.
6.17.11
Measuring the Distance and Bearing from a Saved Waypoint
Prerequisites: Ensure your radio shows the current location on the screen.
Procedure:
1 Press the Menu Select button directly below Optn.
2
or to Dist frm here and press the Menu Select button directly below Sel .
The display shows a list of waypoints.
3
or to the required waypoint and press the Menu Select button directly below Sel .
The display shows the distance and bearing from the current to the selected coordinates.
6.17.12
Location Feature in Emergency Mode
When the Emergency feature is activated, the radio exits the Location menu and returns to the Home
screen for you to view the channel that triggers the emergency signal. You may re-enter the Location
menu while still in Emergency mode as long as Silent Emergency is not activated.
If you have disabled the Location feature on your radio, it automatically turns back on when Emergency
mode is activated.
If there is a solid location signal during Emergency operation, the current location and the location
information received is saved as Emergency and Last Known Location waypoints respectively.
6.18
Mission Critical Geofence (ASTRO 25 Trunking)
This feature allows the radio to use the GPS receiver to determine its location at frequent intervals and
evaluate if the radio is within the Geofence area in real time. Geofence is a virtual perimeter based on
the GPS to define a geographical area on earth.
When the radio enters the predefined Geofence area, your radio receives the Dynamic Regroup
command from the system and immediately connects to a Dynamic Regroup talkgroup. The radio
display shows the new selected Dynamic Regrouped talkgroup with green intelligent light for your
attention. Voice Announcement is also available to support this feature.
Any new text messages received at Geofence is displayed immediately on the radio display.
NOTICE:
If the radio is set up in DVRS, only mobile radio is supported for this feature.
6.18.1
Entering the Geofence Area
Prerequisites: The Voice Announcement and TMS display in this feature are optional. They must be
configured to enable you to hear and see these indicators.
MN003110A01-AJ
Chapter 6: Advanced Features
80
To Next Page
Loading...
