If unsuccessful, the radio sounds a short, low-pitched tone. The display shows Clear all
BT devices failed. The display returns to Bluetooth feature screen.
• Clearing all Bluetooth devices information using the radio menu Clr:
a.
or to Devices and press the Menu Select button directly below Clr.
You hear a short, medium-pitched tone. The display shows Clear all BT devices?.
b. Press the Menu Select button directly below Yes to proceed.
The display shows Please wait to indicate clearing is in progress.
If successful, the display shows All BT devices cleared.
If unsuccessful, you hear the radio sounds a short, low-pitched tone. The display shows
Clear all BT devices failed. The display returns to Bluetooth feature screen.
Postrequisites:
NOTICE: If Re-Pair Timer is set to infinite and you clear keys on the radio, you must clear keys
on all previously paired devices as well. (Please see your accessories manual for further
details.)
6.21
ASTRO 25 (P25) Programming Over Project 25 (POP25)
Also called Over-the-Air Programming, this feature allows configuration data and firmware to be
upgraded to your radio over-the-air. Full use of the radio is retained during the data transfer without
interrupting communication.
If the upgrade happens on the ASTRO 25 and ASTRO Conventional systems, the upgrade pauses to
give priorities to voice call, and continues after the voice call ended. If the upgrade happens on a Wi-Fi
network, the upgrade process runs concurrently with voice calls.
Once a configuration upgrade is downloaded to your radio, you can install new changes immediately or
delay changes to be installed on the radio when it is being powered up.
Your radio can also be configured to allow you to accept or reject an upgrade.
6.21.1
Responding to the Notification of Upgrade
Procedure:
1 The display shows Upgrade? and two short, medium- pitched tones sound every 30 seconds
until the user makes a choice of either accepting, delaying, or rejecting the request.
2 Perform one of the following actions:
• Press the Menu Select button below Acpt to accept the request to upgrade immediately.
• Press the Menu Select button below Optn and select Dlay to delay the request to upgrade
or Rej to reject the request to upgrade.
One of the following scenarios occurs:
• If you choose to accept, the display shows Programming Dont power off to indicate the
upgrade is about to begin. The radio resets to install the upgrade. In the case of configuration data
upgrade, the process only takes a few seconds. In the case of firmware upgrade, the installation
takes several minutes.
MN003110A01-AJ
Chapter 6: Advanced Features
91
To Next Page
Loading...
