July 16, 2004 6881094C28-D
4-2 Recommended Test Equipment and Service Aids: Service Aids
4.2 Service Aids
Refer to Table 4-2 for a listing and description of the service aids designed specifically for servicing
this family of radios. These kits and/or parts are available from the Radio Products Services Division
offices listed in “Appendix B Replacement Parts Ordering” on page B-1. While all of these items are
available from Motorola, most are standard shop equipment items, and any equivalent item capable
of the same performance may be substituted for the item listed.
Table 4-2. Service Aids
Motorola Part
Number
Description Application
8180384M64 Housing Eliminator Fixture Special fixture that allows radio’s internal board to be
mounted externally. Provides easy access to electronic
circuits, required for board-level troubleshooting.
5880384G68 SMA to BNC Adaptor Adapts radio’s antenna port to BNC cabling of test
equipment.
6685833D01 Housing/Casting Separation
To ol
Special tool used to separate housing and casting near
battery latch area for access to inside of radio.
NLN9839 Vacuum Pump Kit Submersible radios only. Vacuum pump with gauge and
vacuum hose. Requires NTN9279 Adapter Kit.
NTN4265 Pressure Pump Kit Submersible radios only. Pressure pump with gauge and
pressure hose. Requires NTN9279 Adapter Kit.
NTN9279 Vacuum Adapter with Gasket
Kit
Submersible radios only. Connects the vacuum/pressure
hose to the radio’s casting.
R1065 Load Resistor, 10-Watt
Broadband
For use with wattmeter.
REX4424 Battery Eliminator Used in place of battery to connect radio to an external
power supply. Requires RLN4510.
RKN4105 USB Cable Kit Connects radio to RLN-4460 Portable Test Set for radio
performance checks, and to Universal Serial Bus (USB)
port on personal computer for CPS programming and tuner
alignments.
RKN4106 RS232 Cable Kit Connects radio to RLN-4460 Portable Test Set for radio
performance checks, and to serial port on personal
computer for CPS programming and tuner alignments.
RLN4510 Battery Eliminator Used in conjunction with the REX4424 to adjust the supply
voltage to 7.5 Vdc. Allows a multimeter to be attached for
monitoring and adjusting voltage and current levels.
RLN4460 Portable Test Set Used for radio performance checks. Connects to radio’s
universal connector and allows remote switching and signal
injection/outputs for test equipment measurements.
RVN4181 Customer Programming
Software (CPS) and Tuner
Software
CPS allows customer-specific programming of modes and
features. Tuner software required to perform alignment of
radio parameters. Can be used for both XTS 5000 and
XTS 2500 products.
To Next Page
Loading...
