Motorola ASTRO XTS 5000 - Battery; Figure 8-4. Inserting the Top Edge of the Battery; Figure 8-5. Pressing the Battery into Place

6881094C28-D July 16, 2004
Disassembly/Reassembly Procedures: Battery 8-5
8.3 Battery
This section explains how to properly attach and remove the battery.
NOTE: The Motorola-approved battery shipped with the XTS 5000 radio is uncharged. Prior to using
a new battery, charge it for a minimum of 16 hours to ensure optimum capacity and
performance.
8.3.1 Attach the Battery
To attach the battery:
1. With the radio turned off, insert the top edge of the battery into the radio’s frame as shown.
Figure 8-4. Inserting the Top Edge of the Battery
2. Rotate the battery toward the radio and press down until the battery clicks into place.
Figure 8-5. Pressing the Battery into Place
To avoid a possible explosion:
• DO NOT charge, remove, or attach the battery in an area
labeled “hazardous atmosphere.”
• DO NOT discard batteries in a fire.
If the radio is programmed for volatile-key retention,
encryption keys will be retained for approximately 30 seconds
after battery removal.
!
W
A R N I N
G
!
!
C
a u t i o
n