Installing the Camera Base to the Mounting Adapter
Note: Be careful not to scratch or touch the dome bubble. The resulting marks or fingerprints may
affect the overall image quality. Keep the protective covers on the outside of the dome bubble
until the installation is complete.
After you install the mounting adapter, mount the camera base to the adapter, using the following steps:
1. Connect the Ethernet port attached to the camera to the Ethernet cable that was pulled through the
adapter.
The connection status LED indicator will turn on once a network link has been established.
2. Position the camera in the mounting adapter, reinserting the connected cable through the cable entry
hole.
3. Align the camera housing clips on the camera base to the camera attachment retainers on the
mounting adapter. Press the camera base into the mounting adapter. The camera base clicks into
place and is held securely.
Initializing a Camera Username and Password
Cameras manufactured after January 1, 2020, do not have a default username or password and will be in a
factory default state.
Important: You must create a user with administrator privileges before the camera is operational.
The first user can be created using any of the following methods:
Installing the Camera Base to the Mounting Adapter 12
To Next Page
Loading...
Need help?
General
