Programming Mode
34
Programming the Interference Eliminator Code
The interference eliminator code helps minimize interference by providing code
combinations that filter out static, noise, and unwanted messages.
1. In programming mode, press S until y displays and the code
number blinks.
2. Press
[or ] to select the code (see page 47).
3. Press and hold
Push to Talk
to exit programming mode, or press
S
to continue programming.
Programming the Available Channels (CLS1410 only)
If you need fewer channels, you can reduce the number of available channels.
1. In programming mode, press S until = displays and the channel
number blinks.
2. Press
[or ] to select the number of channels you want available.
3. Press and hold
Push to Talk
to exit programming mode, or press
S to continue programming.
Note:
The radio retains settings for channels made unavailable.
To Next Page
Loading...
Need help?
General
