Motorola CP040

12
English
GETTING STARTED
SENDING A CALL
RECEIVING A CALL
MONITORING
It is important to monitor traffic before transmitting to
ensure that you do not “talk over” someone who is
already transmitting.
1 Turn your radio on.
2 Use the Channel Selector knob to select the
desired channel.
3 Hold the radio in a vertical position, press the
PTT, and talk at a distance of about
2.5 to 5 cm from the microphone.
4 Release the PTT to listen.
1 Turn your radio on.
2 Adjust the radio’s volume.
3 Switch to the desired channel. To respond,
hold the radio in a vertical position, press the
PTT, and talk at a distance of about
2.5 to 5 cm from the microphone.
1 Press and hold the preprogrammed
Monitor button to access channel traffic.
2 Once channel traffic has cleared, proceed
with your call by pressing the PTT button.
3 A long press of the preprogrammed Monitor
button places the radio in Sticky Permanent
Monitor mode.
• You hear a high-pitched tone.
A short press of the Monitor button cancels
Sticky Permanent Monitor mode and returns
the radio to normal operation.
CP040_EN.fm Page 12 Monday, November 10, 2003 9:16 AM