Programming Features
20
Programming Features
You can change the following features by entering the programming mode (k).
To talk with someone on your two-way radios, these settings must match:
• Channel (15 ch models only)
• Frequency
• Interference Eliminator Code
• Scramble code
• Bandwidth (for optimal clarity)
You can also use k to set the following:
• Call tones
• Microphone Gain
• Scan List (15 ch models only)
• Available channels (15 ch models only)
Note: You cannot enter kwhile a VOX accessory is plugged into the radio.
Entering Programming Mode
You must enter Programming Mode to change your communication settings.
1. Press and hold
M
J
for three seconds while turning on your
radio. The radio beeps and displays k.
1
operation.fm Page 20 Monday, March 3, 2003 12:59 PM
To Next Page
Loading...
