Full Keypad Model Disassembly and Re-assembly: Disassembling and Re-assembling the Radio — General 6-9
6.4.2 Radio Re-assembly - Detailed
6.4.2.1 Dust Cover Re-assembly
1. Insert the tail of the dust cap into the bottom hole of the audio jacks housing opening
(Figure 6-11).
2. Press the dust cap until the tail is fully into the hole.
3. Twist the dust cap counter-clockwise until the cap is seated properly onto the recess.
4. Press the cap again to ensure it fully covers the opening for the audio jack.
.
6.4.2.2 Microphone and Speaker Re-assembly
1. Check that the mic and speaker felts are in position and not damaged. If damaged replace felts.
2. Insert the microphone sub-assembly into the microphone boot.
3. 3. Insert the Boot and microphone sub-assembly into the microphone recess in the housing and
route wires as shown in Figure 6-12.
Note:
Make sure the dust cap is placed between the keypad retainer mounting post and the side
wall of the radio.
Figure 6-11. Dust Cap Re-assembly
12 34
To Next Page
Loading...
