Motorola CP150 - Page 21

Radio Reassembly — Detailed 2-9
b. Bend the wires up from the speaker so the wires are positioned toward the top of the
radio (Figure 2-11).
c. Connect the speaker wire assembly into the 2-pin connector on the main board and
bend the wires at the board connector so the wires are positioned toward the top of the
radio (Figure 2-12).
Figure 2-11. Bend the Wires into an “M” Shape
Figure 2-12. Connect Speaker Wire Assembly
a. Insert dust cover key into housing
at 90° angle.
Figure 2-10. Dust Cover Assembly
Key