4-16 Radio-to-Radio Cloning
4. Press and hold the two side buttons at the same time on the source radio and then power up the
source radio (Figure 4-3). Both radios produce a “clone-entry” tone.
5. Release both side buttons, 1 and 2.
6. When cloning is completed, the source radio produce’s a “clone-exit” tone and both the source
and destination radios reset.
7. Turn both radios off.
8. Disconnect the cloning cable from both radios and turn them on for normal operation.
Figure 4-3. Side Button Locations
Side Button 1
Side Button 2
To Next Page
Loading...
