Motorola CT2 - Using Your Motorola CT2 Phone: Core Functions; Making, Receiving, and Ending Calls; Call Hold Feature

11Using the phone
3. Using the phone
3.1 Calls
3.1.1 Make a call
Lift the handset, when you hear the dial tone, dial the number.
3.1.2 Pre-dial
1. Enter the phone number (maximum 32 digits). If you make a mistake press
D
. Lift
the handset to dial the number.
2. Press
h to dial the phone number over hands-free.
NOTE
You can also make calls using the two touch memory keys, see page 13.
3.1.3 End a call
1. Place the handset back on the base.
Or:
2. Press
h to end a hands-free call.
3.1.4 Receive a call
1. Lift the handset to answer the call.
Or:
2. Press h to answer the call in hands-free.
NOTE
If during a call you want to activate hands-free, press
h and hang up the handset.
To change the ringer volume from high (
) to low ( ) use the switch on the side of the
base.
3.2 Hold
You can place your caller on hold so that you and your caller hear hold music.
1. During a call, press
H and you and your caller will hear hold music.
2. Press
H again to resume your call.
NOTE
If
H is pressed when not on a call a beep will be heard, but it will have no eect on the
functions of the phone.