14 Using the phone
3. Using the phone
3.1 Calls
3.1.1 Make a call
1.
Press <.
2.
Dial the telephone number.
3.1.2 Pre-dial
1.
Enter the phone number (maximum 24 digits). If you
make a mistake press
e.
2.
Press < to dial the phone number entered.
3.1.3 Dial one touch numbers 1 to 9
1.
Press and hold a key from 1 to 9 until the number
is displayed and dialled.
- If no number is stored, you hear a beep.
3.1.4 Call from the phonebook
1.
Press d. The first entry in the phonebook is displayed.
2.
Scroll u or d to the entry you want.
3.
Press < to dial the number.
TIP
Instead of scrolling to browse the phonebook entries, press
the numeric key corresponding to the first letter of the entry
you wish to locate. For example, pressing
2 will show the
entries starting with A. Pressing
2 again will show the
entries starting with B, etc...
3.1.5 Call from the calls list
NOTE
You need to subscribe to your network’s Caller Line
Identification service to be able to see the caller’s number in
the calls list. See “Calls list” on page 20 for more details.
1.
Press u to enter
CALL LOG
menu. You have the options
to access
CALL LIST
. Press m to enter
CALL LIST
. The
first entry in the call list is displayed.
2.
Scroll u or d to the entry you want.
3.
Press < to dial the number.
3.1.6 Answer a call
1.
When the phone rings and flashes in the display, press
< or press v to answer the call via the loudspeaker.
WARNING
When the phone is ringing, avoid holding the earpiece too
close to your ear as it may damage your hearing. Handsfree
activation can suddenly increase the volume in the earpiece
to a very high level. Make sure the handset is not too close
to your ear.
NOTE
If you have subscribed to your Network’s Caller Identity
service and assigned a VIP Group to the caller’s number, the
caller’s details are displayed before the phone starts ringing
(see “Store an entry” on page 16 and “Group melody” on
page 25). You can set your phone to give the default
To Next Page
Loading...
Need help?
General
