Advanced settings 31
8.7 Select a base
You can register your D1000 handset with up to 4 bases.
Once registered, you can switch between bases, for
example, bases at home and at work.
1.
Press m and scroll d to
ADVANCED SET
and press
m.
2.
Scroll d to
REGISTRATION
and press m.
3.
SELECT BASE
is displayed. Press m.
- The available bases are displayed with the current
base number flashing.
4.
Enter the number of the base you want – 1,2,3 or 4 and
press
m.
- When the base is found you hear a beep. If not found,
the display shows
UNREGISTERED
.
8.8 Unregister a handset
1.
Press m and scroll d to
ADVANCED SET
and press
m.
2.
Scroll d to
UNREGISTER
and press m.
3.
Enter the 4 digit master PIN and press m.
- Display shows the registered handset numbers.
4.
Scroll u or d to select the handset you want to delete
and press
m.
-
UNREGISTERED
is displayed on the handset screen.
8.9 PIN
The 4-digit master PIN is used when registering or
unregistering a handset and when changing some settings
on your D1000. The default setting is 0000. You can change
this PIN for more security.
1.
Press m, scroll d to
ADVANCED SET
and press m.
2.
Scroll d to
PIN
. Press m.
3.
Enter the current 4 digit master PIN and press m.
(Default setting 0000).
4.
Enter the new PIN and press m.
NOTE
Make a note of your PIN. If you forget your PIN you will
need to reset your product.
8.10 Reset
This will reset your D1000 to its default settings.
1.
Press m, scroll d to
ADVANCED SET
and press m.
2.
Scroll d to
RESET UNIT
. Press m.
3.
CONFIRM?
is displayed. Press m.
NOTE
Entries stored in the phonebook are retained. After reset,
depending on your country, the welcome mode setting may
be shown on the handset display.
To Next Page
Loading...
Need help?
General
