28 Advanced settings
8. Advanced settings
This setting is useful to access certain network and PABX/
switchboard services.
8.1 Recall time
The default D1000 recall time is suitable for your country and
network operator. It is unlikely that you should need to
change this setting unless advised to do so.
1.
Press m, scroll d to
ADVANCED SET
and press m.
2.
RECALL TIME
is displayed. Press m.
3.
Press u or d to select the setting you want:
SHORT
,
MEDIUM
,
LONG
.
4.
Press m to confirm.
5.
Press > to return to standby.
NOTE
The use of your D1000 cannot be guaranteed on all PABX.
8.2 Dial mode
The default D1000 dialling mode is suitable for your country
and network operator. It is unlikely that you should need to
change this setting unless advised to do so.
1.
Press m, scroll d to
ADVANCED SET
and press m.
2.
Scroll d to
DIAL MODE
. Press m.
3.
Press u or d to select
TONE
or
PULSE
.
4.
Press m to confirm.
5.
Press > to return to standby.
8.2.1 Temporarily switch from Pulse to Tone
dialling
1.
Press and hold *.
The dial mode will change from Pulse to Tone for the
duration of the call.
8.3 Call barring
Prevent certain numbers from being dialled from your
D1000. Store up to four specific numbers, each up to 4 digits
– for example, international or local prefixes.
Bypass call barring by switching the setting Off or On.
NOTE
If you switch Call barring on,
BARR MODE ON
will be displayed
on your screen in standby mode.
8.3.1 Switch call barring on/off
1.
Press m, scroll d to
ADVANCED SET
and press m.
2.
Scroll d to
CALL BARRING
. Press m.
3.
Enter the master PIN (default setting 0000) and press
m.
4.
MODE
is displayed. Press m.
To Next Page
Loading...
Need help?
General
