30 Advanced settings
8.4.3 Dial an easy number
When an easy call number has been stored and the easy call
setting switched on, press any key (apart from
>), to dial
a number.
NOTE
When easy call is switched on, you can still answer any
incoming call as normal.
8.5 Registration
Up to 5 handsets can be registered to one base station.
Additional handsets must be registered to the base before
you can use them.
• The instructions described below apply specifically to
your D1000 handset. If you wish to register another
manufacturer’s handset, the instructions may vary. In this
case, please refer to the manufacturer of the additional
handset.
• The Master PIN is required before you can register or
unregister handsets. The default PIN is
0000
.
8.6 Register a handset
At the base:
1.
Press and hold the p button on the base station for at
least 3 seconds. The base station emits a beep when it
is ready to accept registration. You have 90 seconds in
which to register a handset.
At the handset:
1.
Press m and scroll d to
ADVANCED SET
and press
m.
2.
Scroll d to
REGISTRATION
and press m.
3.
If necessary, scroll u or d to display
REGIST. BASE
and
press
m.
BASE 1 2 3 4
is displayed and the registered
base number is flashing. Enter the number of the base
on which you wish to register your handset.
If you have only 1 base station, press
1. If you have 2
base stations, press
1 or 2, etc.
4.
When the display shows
PIN
----, enter the base PIN.
- When the handset registers with the base, it is
assigned a handset number.
To Next Page
Loading...
Need help?
General
