Motorola GM160

24
English
SCAN
SCAN
Your radio can monitor multiple channels in a
scan list. Your dealer can program up to 16
different channels into each scan list. When
your radio detects activity on a scan list
channel, it will automatically switch to that
channel.
Note: The same channels can be assigned to
different scan lists.
STARTING OR STOPPING SCAN G
The Gsymbol, and the number of the
channel you are transmitting on, will appear on
the display when you start a scan operation.
The green LED indicator blinks during a scan
operation and stops blinking when the radio
switches to a channel.
Note: If you enter Menu Mode while the radio is
scanning, scanning will stop. It will resume
when you exit Menu Mode.
You can start or stop a scan operation either
by:
pressing the preprogrammed Scan button (see
page 5) to start or stop scanning;
–or–
TALKBACK
The Talkback feature allows you to respond to
a transmission while scanning. If a
transmission on a channel is detected while
scanning, the radio will stop on that channel for
a preprogrammed period of time. During this
“hangtime” you may respond by pressing the
PTT.
Note: If transmission stops/ceases or if the PTT is
not pressed for a preprogrammed duration,
the radio will continue scanning. Also, the LED
scan indicator stops blinking while the radio is
in hangtime.
1
u to enter Menu Mode.
2
y or z until
3
u to select
4
y or z until
–or–
5 u to confirm your selection.
System Scan
System Scan
Sys Scan On?
Sys Scan Off?