Chapter 5
RADIO TUNING AND PROGRAMMING
1.0 Introduction
This chapter provides an overview of the Customer Programming Software (CPS) and tuner
program which are designed for use in a Windows 95/98 environment. These programs are available
in separate kits as listed in the Table 5-1. An Installation instruction manual is also included with
each kit.
Table 5-1 Software Installation Kits Radio Tuning Setup
2.0 CPS Programming Setup
The CPS programming setups, shown in Figures 5-1 through 5-3, are used to program the radio.
NOTE
Refer to the appropriate program on-line help files for the programming procedures.
Description Kit Number
EMEA CD ENLN4115_
Software Installation Manual 68P64113B14_
NOTE
Refer to appropriate program on-line help files for the programming procedures.
Figure 5-1 CPS Programming Setup with RIB
RIB
RLN-4008
Rx
Gnd
Data
Tx Data
Cable 3080369B72 (9 PIN)
DB15
Cable 3080369B71 (25 PIN)
Power
Supply
+13,2VDC
Programming
RKN4081
Cable
DB25
Radio
DC
RF
ACC
ZWG0130338-0
To Next Page
Loading...
