4-6 Programming Mode
SCANLST1 Scan List 1 1-01-XXX,
É,
1-16-XXX,
XXX denotes
channel num-
ber.
1-01-001,
1-02-002,
...,
1-16-016
¥ Up to 16 members per scan list. First member is
assigned as Priority Channel if Priority Scan is
started.
¥ When scanning is started, only these 16 members
will be scanned.
¥ Each channel can choose to use Scan List 1, 2 or
3.
¥ By default, all your channels select Scan List 1. If
there is special need to use the other two scan lists
for some of your channels, please consult your
dealer.
¥ Press + and - to move from one scan list member to
another.
¥ To include a channel into the scan list, enter the
desired channel number using the keypad.
¥ To erase a channel number from the scan list, press
#.
¥ Refer to "4.10.3 Setting Up a Scan List" on page
21 for details.
SCANLST2 Scan List 2 2-01-XXX,
É,
2-16-XXX
See Above.
SCANLST3 Scan List 3 3-01-XXX,
É,
3-16-XXX
See Above.
PL1-XXX.X Special PL
Frequency 1
PL1-067.0,
PL1-067.1,
É,
PL1-254.9,
PL1-255.0
¥ You may program any PL frequency from 067.0 Hz
to 255.0 Hz, with 0.1 Hz resolution. This PL can then
be used as receive and/or transmit PL for VFO or
any channel.
¥ Up to three special PL frequencies are available.
¥ Use the keypad to enter the PL frequency directly.
¥ Out-of-bound PL frequency will not be accepted. A
negative tone is heard when attempted.
PL2-XXX.X Special PL
Frequency 2
PL2-067.0,
PL2-067.1,
É,
PL2-254.9,
PL2-255.0
See above.
PL3-XXX.X Special PL
Frequency 3
PL3-067.0,
PL3-067.1,
É,
PL3-254.9,
PL3-255.0
See above.
RW
Parameter
Description Range
Default
from
Factory
Remarks
To Next Page
Loading...
Need help?
General
