11
English
Receiving a Call (Trunked Modes)
1. Turn on the radio and select the desired trunked mode and talk-
group.
2. Listen until you hear activity, then adjust the volume control for
a comfortable listening level. Your radio is now set to receive
calls on the selected trunked mode.
• The YELLOW receive LED will light continuously while the
radio is receiving.
Transmitting on a Trunked Mode
1. Turn on the radio and select the desired trunked mode and talk-
group.
2. Hold the microphone in a vertical position at a distance of
about 1 to 2 inches (2.5 to 5 cm) from your mouth.
3. Press and hold the PTT button and speak slowly and clearly
into the microphone.
• If access to the trunked system was successful, you will hear
a short, high-pitched beep (the “talk permit” tone).
• The RED transmit LED will light continuously while the radio
is transmitting.
4. When your transmission is complete, release the PTT to listen.
OTE:
If you hear a busy tone (a series of short, low-pitched tones), release
the PTT button and wait for a call-back tone (a series of short, high-
pitched tones of equal length). When you hear the call-back tone, you
will have three seconds to press the PTT button, allowing you to make
your call without getting another busy signal.
If a continuous talk-prohibit tone is heard when the PTT button is
pressed, it means that the radio is out of range and you will not be able
to transmit.
To Next Page
Loading...
