Motorola Halo+ - Camera Scanning and Temperature Format; Power Saving and Multi-Camera View

24 Parent Unit Menu Options
4.6.4 Scan cameras
This function is only available when you have more than 1 Baby
Unit (Camera).
1. Press the M button and the menu bar will pop up.
2. Press the < LEFT button or > RIGHT button until is
highlighted, and the
del/ add/ view/ scan menu
will pop up.
3. Press the + UP button or - DOWN button to select
scan ,
and press the O button to confirm.
4. The screen will then display images from different registered
cameras in a loop of Camera , changing
approximately every 12 seconds.
TIP
Quick Method to View Cameras instead of entering into the menu
bar.
Directly press the O button repeatedly to select the available
Camera options from .
4.7 Temperature format
1. Press the M button and the menu bar will pop up.
2. Press the < LEFT button or > RIGHT button until is
highlighted.
3. Press the + UP button or - DOWN button to select
°C or °F .
4.8 Power Saving Mode
1. Press the M button and the menu bar will pop up.
2. Press the < LEFT button or > RIGHT button until is
highlighted.
3. Press the + UP button or - DOWN button to select auto
video off after
5 mins, 30 mins or 60 mins if operating on batteries only.
NOTE
The audio will remain and you can press any key to switch the
video back on.
+
___
, , , ,
V