9
Installing the Handsfree Kit
How to Install the Handsfree
Kit
Caution:
This car kit must be connected to a 5A fuse in
the car fuse panel to prevent fire or other damages if a
short circuit should occur somewhere in the electronic
module. Before installing the car kit, disconnect the
vehicle’s battery.
Before you begin: Unpack, assemble, and test all
components on a service bench.
Car Kit Contents
Interface Cable
The Interface Cable connects the electronic module to the
other system components. It connects the vehicle’s power
and ignition to the car kit and provides some optional audio
connections when the car kit is used with the vehicle’s
radio.
Electronic Module
You can place the electronic module anywhere inside the
vehicle to facilitate convenient connection between the
interface cable and other system components.
Microphone
The microphone cable can be routed along the side of the
vehicle, through the dash, and along the edge of the
windshield. The microphone is placed best near the
rearview mirror and aimed directly toward the user.
BTHandsfree_multi.book Page 9 Tuesday, July 12, 2005 8:46 AM
To Next Page
Loading...
