EasyManua.ls Logo

Motorola IMPRES NNTN8845 - Manual IMPRES Battery Calibration; IMPRES Battery End-of-Service Indication

Motorola IMPRES NNTN8845
184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
English
Note: The IMPRES 2 or IMPRES battery must be outside an IMPRES 2 or
IMPRES charger pocket for more than 30 minutes for automatic Calibration/
Reconditioning.
Manually Initiating Calibration / Reconditioning
Though Calibration / Reconditioning is automatic, there may be
situations in which manual initiation is desired. For example, the
IMPRES 2 or IMPRES charger may be indicating Alternating Amber /
Green for the IMPRES 2 or IMPRES battery, because Calibration is
disabled in the charger. If within 30 minutes that battery is moved to an
IMPRES 2 or IMPRES charger that has Calibration enabled, the last
charging state will resume, preventing automatic start of Calibration /
Reconditioning.
To manually initiate Calibration / Reconditioning, ensure that the
IMPRES 2 or IMPRES battery is removed from the charger for more
than 2-1/2 minutes. Then, perform the following steps:
1. Insert the battery into the charger pocket
2. Within 2-1/2 minutes, remove the battery from the charger pocket.
3. Within 5 seconds, reinsert the battery into the charger pocket.
Calibration / Reconditioning starts immediately, typically beginning with
Battery Discharge (Steady Amber). Calibration / Reconditioning is
complete only after full charge (Steady Green).
IMPRES 2 or IMPRES End-of-Service-Life LED Indication
The IMPRES 2 charger may indicate IMPRES 2 or IMPRES battery
End-of-Service (Alternating Red/Green) upon successful completion of
Calibration / Reconditioning.
As batteries are used, normal wear reduces available capacity. At the
successful completion of Calibration / Reconditioning, IMPRES 2 or
IMPRES chargers compare IMPRES 2 or IMPRES battery capacity to
the battery Rated Capacity. When the capacity is at a very low value,
the IMPRES 2 or IMPRES battery may be nearing its End of Service.
The IMPRES 2 or IMPRES battery remains usable. In some scenarios,
it may be desirable to deploy the battery to someone who does not
require large battery capacity to complete a work shift.
MN002406A01.book Page 9 Monday, December 23, 2019 9:36 AM

Table of Contents

Related product manuals