3
English
Operational Safety Guidelines
• This equipment is not suitable for outdoor use. Use only in dry
locations/conditions.
• Maximum ambient temperature around the charger must not exceed
40 °C (104 °F).
• While a radio is in a charger pocket, the radio may be ON only if the
radio is transmitting data wirelessly, such as using Wi-Fi. Otherwise,
turn OFF the radio.
• Connect the charger to an AC outlet using only a Motorola Solutions
Authorized Power Supply. See Table 3.
• The AC outlet to which the power cord is connected should be close
and easily accessible.
• Make sure the power cord is located where it will not be stepped on,
tripped over, or subjected to water, damage, or stress.
• Connect the power cord only to an appropriately fused and wired AC
outlet with the correct voltage, as specified on the product.
• Disconnect from line voltage by removing the power cord from the
AC outlet.
• Connect no more than the appropriate number of chargers to a 15 A
circuit or 20 A circuit, as limited by any certified power strip being
used.
Note: Daisy chaining power strips are NOT RECOMMENDED. Limit circuit
loading below 80% of the circuit rating.
Operating Instructions
The IMPRES Adaptive Charger System is a fully automated battery
care system. Follow these simple steps:
1. Place the radio/IMPRES battery into the charger.
2. Remove the radio/IMPRES battery when it's fully charged (LED
turns steady GREEN).
The charger pocket accommodates either a radio with an attached
IMPRES 2 or IMPRES battery, or an IMPRES 2 or IMPRES battery
alone. Prior to charging a radio with an IMPRES 2 or IMPRES
battery, radio can be in the ON state only when the radio is
transmitting data wirelessly. Otherwise, turn OFF the radio.
Batteries charge best at room temperature.
MN002406A01.book Page 3 Monday, December 23, 2019 9:36 AM
To Next Page
Loading...
Need help?
General
