Motorola JT 1000

MAEPF-
MAEPF-
MAEPF-
MAEPF-
MAEPF-
MAEPF-
MAEPF-
MAEPF-
20
Quik-Call II™ Decode Signalling
A. Description
Quik-Call II decode is a convenient way for a
dispatcher to voice page an individual or group. Quik-
Call II decode also eliminates the need for you to
listen to traffic that is of no concern. This feature is
enabled on a per-channel basis, and available as
individual call, group call, or dual call.
B. Operation
To turn on and operate Quik-Call ll:
1. Turn the radio on.
2. Activate Quik-Call II by placing the 3-position
toggle switch in the (A) position (if so
programmed), or by rotating the channel
selector to the desired channel with Quik-Call ll
programmed. The display will show QC.
3. When a page is received, the LED flashes green,
the call-received annunciator flashes, and an
interrupted alert tone (individual call) or
continuous alert tone (group call) is heard. A
voice message will follow. The LED will continue
to flash for the entire length of the message.
4. Return the radio to the Quik-Call II paging mode
by pressing the monitor button. If the monitor
button is not pressed, the radio will “auto-reset”.
The Quik-Call II feature is factory programmed
for auto-reset. When carrier is detected, the
automatic reset timer is stopped; when carrier
is lost, the auto-reset timer is started over.
Notes:
• Quik-Call II auto-reset is cancelled when the
monitor button is pressed or when the
channel is changed. The auto-reset timer is
started over if it was running when a Quik-Call
II was decoded, or when a successful
transmission was initiated.
• Quik-Call II will be decoded and an alert
generated regardless of the PL or DPL
squelch configuration on that channel.
A
B
C
20 Radio Operation
with Features (cont.)